Four RTX 5080 power-cap sweeps: distinguish the configured limit from actual draw
A QEngine 1.3.5.9 community report includes per-card sweeps and explicit corrections. Higher caps did not produce a consistent throughput gain on this rig; it does not establish universal RTX 5080 savings.
Source: club-3090社区功耗扫描及更正评论
Lowering a configured power limit does not reduce electricity use by the same percentage. On 15 November UTC, club-3090 issue #2041 published per-card sweeps on a four-RTX-5080 machine, followed by MoE results and explicit corrections. This is one community report from one rig, not an independent AraoAI reproduction.
The setup pins QEngine 1.3.5.9, build ee98bd1, with four 16GB cards connected through a PCIe Gen5 x8 switch. The dense workload uses Qwen3.8-27B INT4, TP4, a 262144 context limit and FP8 KV in VRAM. The Flash-Next follow-up uses different concurrency and host-RAM KV placement. Those workloads must be interpreted separately. The tool sweeps one card at a time in 10W steps with repeated runs; this is not a simultaneous whole-rig cap experiment.
The correction chain matters. GPU0 permits 252–360W, GPUs 1 and 2 permit 250–396W, and GPU3 permits 250–360W. The original prose incorrectly grouped GPU3 with GPU0 at a 252W minimum. GPU0's sweep actually starts at 260W, while GPU3 starts at 250W. The author also withdrew the claim that a knee had been observed within the reachable range. A shared product name is not enough to assume identical per-card limits.
The narrow finding is that increasing the cap did not consistently buy throughput for these workloads on this machine and engine. In the MoE follow-up, actual draw remained below the configured limits. Permission to consume more power is not measured consumption; conversely, a cap reduction is not a measured saving. No wall-socket energy measurement was supplied, so no whole-system saving percentage is calculated here.
A useful local procedure is to read each card's legal limits, then record actual draw, throughput and power-throttling status together on your own workload. Preserve the correction history rather than copying an attractive recommended wattage. Original tables and corrections: https://github.com/noonghunna/club-3090/issues/2041